Telex Stratus 50 manual Stratus Controls, Microphone Gain Adjustment, Ear Cushion Replacement

Page 9

Stratus Controls

Power

Switch the ON/OFF button to turn the Stratus on or off. Green LED indicates power on.

Low Battery

Red LED indicates 20 percent or less battery life remaining.

Figure 11

Stratus Battery Box

Microphone Gain Adjustment

The microphone gain has been factory-adjusted to the nominal level required for aviation use, and it should normally not require readjustment. Any changes to the mic gain should be done by a qualified avionics technician. To access the gain trimmer, insert a small flat-blade screwdriver through the access hole in the mic assembly. Clockwise rotation of the trimmer increases gain.

MIC GAIN

ADJUSTMENT

ACCESS

Figure 12

Microphone Gain Adjustment

Ear Cushion Replacement

To remove an old ear cushion, simply grasp it and pull it off the earcup. To install a new ear cushion, start at the top of the earcup. Place the flap on the back of the ear cushion over the lip along the top of the earcup. Then pull the bottom of the ear cushion down over the lip at the bottom of the earcup.

Page 7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Telex Stratus 50 Digital Reference View General Description Design Features See FigureAuto Shut-Off Microphone Bias Voltage RequirementsHeadset Operation Headset PowerMicrophone Placement Side View Top View Headband Size Adjustment Microphone Gain Adjustment Ear Cushion ReplacementStratus Controls Wiring Diagram Receivers SpecificationsOrdering Information Telex COMMUNICATIONS, INC. Limited Warranty Customer Service Page LIT000010 Rev a 04/2006
Top Page Image Contents