Precautions

NETWORK MONITOR CONFIGURATION 9

yyThis monitor does not support station partitioning.

yySome keyboards and mouse devices may not be compatible with this monitor.

yyAfter adding a new U-Series monitor to an existing U-Series multi-computing environment, or after modifying its configuration (cable connection), you may need to reboot the PC to ensure normal op- eration.

yyIf a USB cable is disconnected from a U-Series monitor when it is on, the primary station may log off or other errors may occur. In this case, connect the USB properly and reboot the PC.

yyThe screen saver for each station is not supported in the multi-computing environment.

yyIf you disconnect then re-connect the USB cable of the standard station, the desktop slideshow set- tings will be disabled.

yyDue to the internal virus detected in WMS 2011 Window Media Player, malfunctions including video freezing or disconnection may occur. But, the repeat playback function may not work properly in Windows Media Player in WMS 2011.

*Please note that video playback may vary according to PC performance.

yyIf the keyboard or mouse is connected to PC via a USB hub, the system may become unstable. In this case, you need to reboot your PC.

yyRebooting your PC, running the remapping function of MultiPoint Manager, or switching between maintenance mode and normal mode may cause the mouse and keyboard of each monitor screen to cross between stations. The same issue may occur when installing a specific program that is not verified as being compatible with WMS 2011.If this issue occurs, please reboot the PC.

yyWMS 2011 is a 64-bit operating system. When installing a program in this operating system, make sure that the program supports a 64-bit operating system. If a program is only designated 32-bit and does not support a 64-bit operating system, it may not install or operate properly.

yyThe screensaver may run when the PC boots up. When the screensaver is running, it may not switch off immediately after keyboard or mouse input (it will take approximately two minutes). This is not related to the monitor's performance.

yyBe sure to check that the monitor is switched on before you power on the PC. Otherwise, this may cause a malfunction.

yySome 32-bit designated programs may be compatible with WMS 2011.

For more information on these programs, please visit the Microsoft community sites below. http://rdcompatibility.com/compatibility/Default.aspx?srv=4 http://rdcompatibility.com/compatibility/Default.aspx?v=1

yyUpdates and patches for the WMS 2011 operating system can be downloaded from the DLC (Microsoft Download Center) site below: http://www.microsoft.com/download/en/details.aspx?id=26945

ENGLISH