PLUS Vision V-1100Z user manual Thermal Protector, When the Status Indicator is Lit/Flashes

When the STATUS Indicator is Lit/Flashes

STATUS Indicator	POWER Indicator	Action to Take
STATUS	POWER	It is timer to replace the lamp.
		The lamp timer has exceeded 1,000 hours.
		Replace the lamp cartridge.
Lit red	When power is on:
	Lit green
	When power is off:
	Lit amber
STATUS	POWER	The lamp's service life has ended.
		The lamp timer has exceeded 1,100 hours. The lamp
		will not light. Replace the lamp cartridge.
Lit red	Lit amber after 90 seconds
	of flashing in amber

Thermal Protector

When the internal temperature of the projector becomes abnormally high, the STATUS indicator will flash red (at a rate of once per second) and the POWER indicator will light red.

The thermal protector is activated and the power of the projector is switched off simultaneously. Should this occur, proceed with the following actions.

1.Switch off the power and disconnect the power plug from the wall outlet.

2.Check the following matters and take the required measures.

When the projector is being used in a location that has a high ambient temperature, set it up again in a cool location. Check the outflow and intake holes and clean them if they are obstructed.

3.Wait about 60 minutes until the temperature of the projector drops.

If after having performed the above matters, the problem still has not been solved, please contact your store of purchase.

E-62