Mitsubishi Electronics X70U user manual User memory for signal setting

HORIZ. POSITION

VERT. POSITION

FINE SYNC.

TRACKING

COMPUTER INPUT

RRGGBB

HOLD

USER MEMORIZE

U

MEMORY CALL

4 SIGNAL
MEMORY CALL	Use to select AUTO, USER 1 or USER 2. See below.
HORIZ. POSITION ....	Use to adjust the horizontal position of the image.
VERT. POSITION	Use to adjust the vertical position of the image.
FINE SYNC	Use to synchronize the projector with PC input signals so
	that the image is not blurred.
TRACKING	Use to avoid image noise such as wide stripes.
COMPUTER INPUT ....	The unit adjusts itself automatically when connected to
	either DVD players with a component video output
	terminal (Y, CB, CR or Y, PB, PR) or equipment with HDTV
	signal output capabilities. In cases where the unit is
	connected to equipment that include an RGB output
	terminal and which output HDTV signals, adjust the unit
	to RGB mode.
HOLD	Adjusts the image when curving near the top.

5 SIGNAL - USER (Normally, there is no need for adjustments.)

SIGNAL

A

Opt

XGA60

AUTO

208

22

24

1056

RGB

AUTO

DELETE DEFAULT

ENGLISH

CLAMP POSITION/	SIGNAL–USER
CLAMP WIDTH .........If you use something similar, the brighter colors of the
			CLAMP POSITION	0
projected image may become blurred. In this case, adjust
			CLAMP WIDTH	+ 5
CLAMP POSITION or CLAMP WIDTH.
			HORIZ. PIXELS	800
HORIZ.PIXELS .. Use to adjust the width of the image. The image size
			VERT. LINES	600
grows wider as the number increases. (Adjust to the			PLL	AUTO
horizontal pixels of the input signal for normal setting.)
		?	VERT. SYNC.	AUTO
VERT.LINES ...... Use to adjust the height of the image. The image size
			SHUTTER(U)	0
grows higher as the number increases. (Adjust to the
			SHUTTER(L)	0
vertical lines of the input signal for normal setting.)

PLL ...................... Use to adjust the image when skewed on top. Select AUTO for normal setting.

VERT.SYNC. ...... Use to adjust the image when its motion does not run smoothly. Select AUTO for normal

setting.

SHUTTER(U) ..... Use to adjust the image when the noise etc. appears on top part of image.

SHUTTER(L) ...... Use to adjust the image when the noise etc. appears on bottom part of image.

User memory for signal setting

This projector can memorize the maximum of 2 signal menu settings.

Memorizing the setting

1.Select MEMORIZE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2).

3.Press the ENTER button.

Initialite the setting which has been changed (Default)

Select RESET in the SIGNAL menu, and press the ENTER button.

•When initializing, selection buttons will not work for about 2 - 18 seconds.

Select the user setting

Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2).

Reset the recorded setting

1.Select DELETE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2).

3.Press the ENTER button.

The recorded setting will be reset.

EN – 17