Mitsubishi Electronics SE1U Label Locations, Power Supply Cord Selection, Important Precautions

LABEL LOCATIONS

CAUTION Label

MODEL NO. /

RATING Label

E166452

SERIAL NO. Label

MANUFACTURED;

SERIAL NO.

CAUTION Label

CAUTION Label

CAUTION Label WARNING Label

POWER SUPPLY CORD SELECTION

If your line voltage is 220 to 240V, use one of the following types of cable.				Using
Plug		Plug
configuration Plug type	Line voltage	configuration Plug type	Line voltage
EURO	220 – 240V	Australian	200 – 240V	Before
		240V
		10A
UK	220 – 240V	Switzerland	200 – 240V
		240V
		6A
Use a 5A fuse which is approved by ASTA		North American	200 – 240V
or BSI to BSI362.

Always replace the fuse cover after	240V
	15A
changing the fuse.

IMPORTANT PRECAUTIONS

Moisture Condensation

Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature.

Place and Manner of Installation

•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the LCD panel.

•Avoid locations with oil or cigarette smoke. Doing so will dirty the LCD panel and other optical parts, shortening their lives, and darkening the screen.

•Using this instrument near a TV or radio may cause intereference to the images or audio sound. If this happens, move it away from the TV or radio.

•Moving the projector from a low-temperature room to a high-temperature room may cause condensation on the lens or internal parts in the instrument. If you continue to use it in that situation, the malfunction may result. Ensure to wait until the condensation naturally disappears.

•In a high altitude location where air is thin, cooling efficiency of the scanner is reduced so use it with the ambient temperature being lowered.

8 9