Mitsubishi Electronics SD206U user manual Indicators, Normal condition, Abnormal condition

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.

The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.

STATUS indicator POWER indicator

Normal condition

POWER	STATUS	CONDITION	NOTE
	Off	Stand-by
Steady red
	Off	Power up process (About 4 seconds)
Blinking red
		The power is on. (Normal condition)
Steady green	Steady green

• Lamp cooling down. (About 90 seconds)

•Lamp lit up (About 60 seconds)

Steady green Blinking green

Abnormal condition

POWER		STATUS				CONDITION		POSSIBLE SOLUTION
	Off	Blinking green about			Lamp failure		•	Replace the lamp and reset the lamp hour.
		30 seconds after
		power on.
					Color wheel failure		•	Contact your dealer.
Steady green		Steady amber
		about 5 seconds after
		power on.
							• Check if the fan is clogged with dust or dirt and
		Steady green about			Fan failure			clean it.
							• If the above solution is not effective, contact your
Blinking green		20 seconds after
								dealer.
		power on.
							• Clean the ventilation grilles.
							• Relocate the projector to a cooler place.
							• For the directly shut down, it will check the
								temperature first, if it's too high, it will start
		Steady red about 10			Abnormal temperature			cooling for 90 seconds.
Steady green		seconds after power					•	If it's abnormal shut down in the previous time,
								while the temperature is too high, it will start the
				on.
								cooling process after 90 seconds when the
								temperature is still too high.
					95% Lamp life exceed		•	Replace the lamp and reset the lamp hour.
Steady green		Blinking red
					Lamp life end		•	Replace the lamp and reset the lamp hour.
		Steady red about 5
	Off	seconds after power
				on.
	N/A		N/A		Lamp cover open		•	Put back the lamp cover.

EN-26