Mitsubishi Electronics XD3200U user manual ProjectorView Initial setting, EN-15

Page 15

ProjectorView (continued)

Initial setting

To load information on the projector such as model name and lamp operating time, set the projector data in advance. Click the SETUP button on the ProjectorView main screen. The Projector Setup screen appears. Enter data according to the description of each setting item.

(Note)

You can’t change the Projector model, Serial number, Operating hours, and Lamp hours. They are loaded from the projector and displayed when the LAN controlled mode of Telnet setting is set to ON.

The entry field of each setting item contains a blank character by default. When setting these items, delete the blank characters.

Each setting item is described as follows:

Projector name*

Name to identify the projector

 

 

Projector model

Model name of the projector

 

 

Projector location*

Location of the projector

 

 

Serial number

Serial number of the projector

 

 

SMTP IP address*

IP address of the SMTP server used for e-mail transmission (Example: 192.168.0.1)

 

 

E-mail address*

e-mail address to receive alert notification e-mail (Example: administrator@XXX.XXX.XXX)

 

(up to 64 characters)

 

 

E-mail host*

User-defined string displayed at the Internet header of e-mail message (Example: user)

 

 

E-mail from*

Sender of alert notification e-mail (Example: PJView@XXX.XXX.XXX)

 

 

Operating hours

Cumulative projector operating time

 

 

Lamp hours

Cumulative lamp operating time calculated based on that LAMP MODE is LOW.

 

 

Installation date*

Date when the projector was installed

 

 

Last lamp replacement date*

Date when the lamp was last replaced

 

 

Last maintenance date*

Date when the projector was last maintenanced

 

 

Virtual remote enabled

Display or hide the virtual remote controller (Check the box to display.)

 

 

* ) For data entry, use single-byte alphanumeric characters and symbols (+ - / = @ * _ ! ? . , ; : # $ % & ( ) < > [ ] { } “ ‘).

(Note)

When the “Standard” lamp mode is selected, the indicated lamp operating time may exceed the indicated operating time.

EN-15

Image 15
Contents LAN Control Utility Contents System requirements Preparation/SetUpPreparation before using the network function Major functionsEN-3 InstallationPreparation/SetUp ConnectionEN-4 EN-5 Setting the IP address of the projectorEN-6 When using a Dhcp serverEN-7 When not using a Dhcp serverEN-8 Telnet settingEN-9 Setting the password Password SetupSetting the display language of ProjectorView language Setting the LAN control LAN-Controlled ModeEN-10 Setting the PJLink certification PJLink certification Mode Save and exitEN-11 EN-12 Using the ProjectorViewHow to start up ProjectorViewProjectorView ProjectorView main screenEN-13 ProjectorView Virtual Remote controller Mail notification functionEN-14 EN-15 ProjectorView Initial settingEN-16 Support for the PJLink functionSupport for the PJLink function Terms and definitionsEN-17
Related manuals
Manual 53 pages 2.75 Kb