Preparation/SetUp (continued)
Telnet setting
Setting of password, display language, LAN control, and PJLink™ certification using telnet.
This section describes how to set the password, display language on the ProjectorView screen, LAN control, and PJLink™ certification that are necessary for the operation state control tool (commercially available) that uses the projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.
1 | Start the |
| |
| • Select [Start] - [All Programs] - [Projector] - |
| |
| Windows® XP). |
|
|
2 | Press the + buttons on the left pane to expand the |
| |
| tree structure until the IP address you set appears. |
3 | Click the Telnet Configuration tab. |
|
4 | Select the Connect tab. Press the Enter key within |
| |
| 5 seconds after the message shown on the right |
| appears. |
| • When it passes 5 seconds without any operation |
| on this screen, the screen is shaded and no key |
| operation is accepted. In this case, click the |
| Connect button again to continue setting. |
5
The setting menu appears.