Preparing the projector for operation
Getting ready for projection
1.Connect the power cord provided to the projector.
2.Connect the power cord to the wall power outlet.
3.Remove the lens cap.
Warning:
•Do not look directly into the lens when projector is “ON”.
•The lens cap is for protecting the lens. If you leave the power on with the cap on, the cap may be warped. Please remove the lens cap when you turn the power on.
•This projector is equipped with the power cords for both U.S. and Europe. Use the appropriate power cord for your country.
•A
•The supplied power cord for U.S. is used for 120V only. Never connect to any outlet or power supply having a different voltage or frequency. If you connect to the power supply having a different voltage, please use the appropriate power cord.
•Use
•Do not place any objects on the power cord, and keep the projector away from heat sources to avoid break- ing the power cord. A broken power cord can cause fire or electric shock.
•Do not revise or alter the power cord otherwise it may cause fire or electric shock.
Contact your dealer if the cord is broken.
Caution:
•Plug in firmly and unplug by holding the plug, not by pulling the cable out.
•Do not plug in or out with wet hands. It may cause an electric shock.
Adjusting the angle of projection
For the best result, project onto a flat screen with a 90 degree angle to the floor. If necessary, tilt the projector by adjusting two foot adjustments on the bottom of the projector.
screen | Adjustment foot |
|
1.Lift the projector to the appropriate angle.
2.Press the Front height adjuster button, this will al- low the adjustment foot (up and down) to slide out to the position.
3.Release the Front height adjuster button to lock the feet in that position.
Front height adjuster button
Adjustment foot (up and down)
After using the projector
4.Return the adjustment foot (up and down) into the projector by pressing the Front height adjuster but- ton.
When the left and right angles are different Adjust the angles with adjustment feet (right and left), which are on the bottom of the projector.
Adjustment foot (right and left)
Important:
•The image becomes trapezoid shape when the
screen or project is not level. Use KEYSTONE button and { or } buttons on the remote control to adjust, however, the circumference of the image may not be focused.
•Screen on a flat wall with a 90˚ angle to the floor.
•Align projector to produce a full screen display as illustrated on page 9.
•The distance from the projector to the screen must be compatible with screen size chart on page 9. Note the distance from the screen chart.
EN – 12