Using the remote control
Battery installation
Use two AAA size batteries.
1.Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.
2.Load the batteries making sure that they are positioned correctly (+ to +, and - to
• Load the batteries from - spring side, and make sure to set them tightly.
3.Replace the back cover.
1 | 2 | 3 |
Important:
•Do not combine a new battery with an old one.
•Load batteries in the correct position.
•Do not heat, take apart, or throw batteries into fire.
•Do not try to recharge batteries. Do not use rechargeable batteries.
•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.
Operation area
The range for operation is about 10 m (about 32 feet) when the remote control points to the projector. The dis- tance to the screen back to the projector must be less than 6 m (about 20 feet). Depending on the type of the screen, the distance will be different.
20˚ | 20˚ |
15˚ | 15˚ |
30˚
30˚
Important:
Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m (6.5") between the remote control sensor and fluorescent lamp on the remote control may not work correctly.
EN – 8