Mitsubishi Electronics LVP-X400U user manual User memory for signal setting, Signal

HOLD

USER MEMORIZE

MEMORY CALL HORIZ. POSITION VERT. POSITION FINE SYNC. TRACKING COMPUTER INPUT

4 SIGNAL
MEMORY CALL	Use to select AUTO, USER 1 or USER 2. See below.
HORIZ. POSITION ....	Use to adjust the horizontal position of the image.
VERT. POSITION	Use to adjust the vertical position of the image.
FINE SYNC	Use to synchronize the projector with PC input signals so
	that the image is not blurred.
TRACKING	Use to avoid image noise such as wide stripes.
COMPUTER INPUT ....	The unit adjusts itself automatically when connected to a
	DVD player with a component video output (Y, CB, CR). In
	the case ( Y, PB, PR). In the case the projector is connected to
	equipment that includes RGB output terminal, adjust to
	RGB mode.
HOLD	Adjusts the image when flagging occurs near the top of the
	screen.

SIGNAL

A

U

RR GG BB

Opt

XGA60

AUTO

0

0

0

0

RGB

AUTO

DELETE DEFAULT

ENGLISH

5 SIGNAL - USER (Normally, there is no need for adjustments.)
CLAMP POSITION/
CLAMP WIDTH	If you use something similar, the brighter colors of the	SIGNAL-USER
	projected image may become blurred. In this case, adjust	CLAMP POSITION	0
	CLAMP POSITION or CLAMP WIDTH.	CLAMP WIDTH	0
HORIZ.PIXELS ..	Use to adjust the width of the image. The image size grows	HORIZ. PIXELS	0
	wider as the number increases. (Adjust to the horizontal	VERT. LINES	0
	pixels of the input signal for normal setting.)	PLL	AUTO
VERT.LINES	Use to adjust the height of the image. The image size grows	VERT. SYNC.	AUTO
	higher as the number increases. (Adjust to the vertical lines	SHUTTER(U)	0
	of the input signal for normal setting.)	SHUTTER(L)	0
PLL	Use to adjust the image when skewed on top. Select AUTO for	SHUTTER(LS)	0
	normal setting.	SHUTTER(RS)	0
VERT.SYNC	Use to adjust the image when its motion does not run
	smoothly. Select AUTO for normal setting.
SHUTTER(U)	Use to adjust the image when the noise etc. appears on top part of image.
SHUTTER(L)	Use to adjust the image when the noise etc. appears on bottom part of image.
SHUTTER(LS) ....	Use to adjust the image when the noise etc. appears on left side of image.
SHUTTER(RS) ...	Use to adjust the image when the noise etc. appears on right side of image.

User memory for signal setting

This projector can memorize the maximum of 2 signal menu settings.

Memorizing the setting

1.Select MEMORIZE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to record (USER 1 or USER 2).

3.Press the ENTER button.

Initialite the setting which has been changed (Default)

Select RESET in the SIGNAL menu, and press the ENTER button.

•When initializing, selection buttons will not work for about 2 - 18 seconds.

Select the user setting

Select MEMORY CALL in SIGNAL menu, and press the $ or % button to select the memory (USER 1 or USER 2).

Reset the recorded setting

1.Select DELETE in the SIGNAL menu, and press the ENTER button.

2.Press the $ or % button to select the memory which you wish to reset (USER 1 or USER 2).

3.Press the ENTER button.

The recorded setting will be reset.

EN – 17