Mitsubishi Electronics MC100 manual Communications Setup

Page 20

6 COMMUNICATIONS SETUP

Once you have the Rack Computer installed, a monitor and any peripheral devices you require for your application connected, you are ready to power up the computer. Press and release the Power Control Switch located on the front panel of the computer (shown on page 12).

Consult the ACe-Z85 Embedded Processor Board Manual, part number MAN- ACZ85-001 to set up your Industrial Rack Computer’s BIOS.

MC100 Series Rack Mount Computer

MAN-RCKPC-001

Image 20

Contents Rack Mount Computers Manual P/N MAN-RCKPC-001 AVG AutomationContents Contents Chapters IntroductionManual Organization Introduction What you need to get started Technical SupportThis page intentionally left blank Models and Equipment Model Number/DescriptionAccessories Accessories and Optional SoftwareOptional Software Mechanical Specifications SpecificationsComputer Specifications Mount the Unit Make Connections Installation MountingInstallation External Components Cdrom Drive Reset ButtonFloppy Disk Drive Power Connector Power SwitchParallel Port Connector Two USB Universal Serial Bus ConnectorsVideo Connector Mouse ConnectorKeyboard Connector Ethernet ConnectorCommunications Setup Expansion Card Installation Maintenance and UpgradesUpgrades Maintenance and Upgrades Maintenance Internal ComponentsUse the damp cloth to wipe the computer housing Error / Improvement Report MAN-RCKPC-001