Advanced features
Password function
This projector is equipped with the password function that is designed for prevention of theft and wrong operation by children and restriction on operation by other than specified users. The password function has two modes as follows.
DISPLAY INPUT........... When the projector is turned
on, the startup screen (or splash screen) will appear and stay on the screen until the password is entered. When the password is entered, the startup screen will switch to the regular operation screen.
MENU ACCESS........... All the buttons except for the
POWER button on the projector are disabled. (The buttons on the remote control are enabled.) You can use this mode as a measure of prevention of wrong operation by children and restriction on operation by other than specified users.
To enable the password function:
1. Display the FEATURE menu.
. Press the p or q button to select PASSWORD FUNCTION.
. Press the u button to change the mode among DISPLAY INPUT 
and MENU ACCESS 
.
•When the password has already been set, the mode won’t be changed. In such cases, press the ENTER button to cancel the password function and try again.
4.Press the ENTER button.
•The screen for setting the password function will appear.
DISPLAY INPUT
LOCK | OK |
|
|
|
|
|
|
UNLOCK | OK | ||
|
|
|
|
5.Press the ENTER button.
• The screen for entering a password will appear.
PASSWORD
CONFIRM
1
4 | 2 | O K : ENTER |
| CANCEL : MENU |
3
6.Enter a 4 - 8 digit password using the , , or buttons on the remote control as shown below. (=1, =2, =3, =4)
7.Press the ENTER button.
•To cancel the procedure, press the MENU button.
8.Enter the password again for confirmation using the same steps.
9.Press the ENTER button.
•If the entered passwords don’t match, an error message will appear.
•To cancel the procedure, press the MENU button.
To cancel the password function:
1. Display the FEATURE menu.
. Press the p or q button to select PASSWORD FUNCTION.
. Press the ENTER button.
•The screen for canceling the password function will appear.
DISPLAY INPUT
LOCK | OK |
|
|
|
|
|
|
UNLOCK | OK | ||
|
|
|
|
4.Press the ENTER button.
•The screen for entering the password will appear.
PASSWORD
1
4 | 2 | O K : ENTER |
| CANCEL : MENU |
3
5.Enter a 4 - 8 digit password using the , , or buttons on the remote control as shown below. (=1, =2, =3, =4)
6.Press the ENTER button.
•If you enter a wrong password, an error message will appear.
•To cancel the procedure, press the MENU button.
Important:
•Disable the password by pressing the MENU and ENTER buttons on the control panel at the same time about three seconds.
Kensington Lock
This projector has a Kensington Security Standard connector for use with Kensington MicroSaver Security System. Refer to the information that came with the Kensington System for instructions on how to use it to secure the projector. Please contact Kensington Technology Group below.
Kensington Technology Group 2855 Campus Drive
San Mateo, CA 94403, U.S.A. Phone: +1-