Mitsubishi Electronics CP9500DW Before Calling for Service, Instructions for Transportation

Page 23

ERROR MESSAGES & COUNTERMEASURES

BEFORE CALLING FOR SERVICE

For the following symptoms, check the unit again before calling for service.

Symptom

 

Check & Remedy

 

 

The power is not turned on.

Is the power cord plug disconnected from the outlet?

 

Connect the power cord plug to the outlet firmly.

 

The protective circuit may be working. Turn off the power and wait for

 

 

about two minutes. Then turn on the power again.

 

 

The door doesn't close.

Are you turning off the power during printing procedure?

 

Turn on the power and then close the door.

 

 

The image is not printed.

Is the image data sent to this unit?

 

Make sure that the image data is sent to this unit.

 

Is the print paper or the ink ribbon used up?

 

Check them.

 

Is the ink cassette installed correctly?

 

Install the ink cassette correctly.

 

 

The image data is not transferred.

Is the input select switch set correctly?

 

Check the setting.

 

 

The personal computer does not recog-

Is the same SCSI ID number allocated to other equipment?

nize this unit.

Change the SCSI ID number.

 

Is the input select switch set correctly?

 

Check the setting.

 

 

 

PRECAUTIONS

FEATURES

 

CONNECTIONS

PREPARATION

SHOOTING

TROUBLE-

 

 

INSTRUCTIONS FOR TRANSPORTATION

When transporting this unit for some reason such as repair, follow the instructions below.

1. Use the original packaging

The genuine package unit may not endure more than one round trip. If the unit is transported with the package unit more than one round trip, it may not be guaranteed.

Purchase another package unit when transporting this unit again.

Pack the unit with all the accessories (ink ribbon, print paper, ink cassette, and paper flanges) removed.

2. Turn off the power after the PAPER/INK RIBBON indicator blinks.

After removing all the accessories, close the door with the printer’s power on. After the PAPER/INK RIBBON indicator blinks, turn the power off.

3. If the ink ribbon, print paper, or ink cassette can not be taken out, consult with your dealer.

20

Image 23
Contents CP9500DW Information Page Contents Protective Measures Safety PrecautionsFor Long Operating Life Safety PrecautionsInstallation Locations Other Cautions Special Features Special FeaturesUnwrap the packing UnpackingUnpacking Separate the printer from the cushionsFront Panel Features & FunctionsLeft Side Rear Features & FunctionsSide and Rear Panel Set the Scsi ID switch Connection with Scsi Data Signal EquipmentConnecting to Personal Computer Example Press the Power button to turn off the powerConnections Connection with USB Data Signal EquipmentSetting DIP Switches Setting of DIP SwitchesBefore Operation Installation of Print PaperBefore Operation 4Install the print paper into the unit1Load the ink ribbon in the ink cassette as shown below Installation of INK RibbonInstalling the INK Ribbon Installing the INK CassettePush the center of the door to close Push the ink cassette toward the back of the unitStorage of Paper / INK Ribbon SET Handling of Paper / INK Ribbon SETBefore Printing After PrintingInstallation of Printer Driver Indications on the Front Panel and Countermeasures Error Messages & CountermeasuresRemove the ink cassette Error Messages & CountermeasuresWhen the manual & cut mode has been selected Overcoming Paper JamsUse the original packaging Before Calling for ServiceOthers Contents Instructions for TransportationPaper Flange Cleaning CleaningPreparations for Cleaning Thermal Head CleaningContents of CD-ROM SpecificationsSpecifications Mitsubishi Electric Europe B.V UK Branch
Related manuals
Manual 26 pages 22.9 Kb