Mitsubishi Electronics MLM400 user manual Attaching LCD Options, Lay the screen face down

Page 6

Attaching LCD Options

You can attach mounting accessories to the LCD monitor in one of the following two ways:

1. In the upright position

Ventilation Requirements for enclosure mounting

To allow heat to disperse, leave space between surrounding objects as shown in the diagram to the right.

MLM300

100

 

*

 

 

 

 

 

100

 

100

100

 

 

 

100

 

 

2. Lay the screen face down

*Ambient temperature should be less than 40 deg C

Protective Sheet

Table

Tabletop Stand

To avoid damaging the screen face, place the protective sheet on the table to lay the LCD on. The protective sheet was wrapped around the LCD in the original packaging.

This device cannot be used or installed without the Tabletop Stand or other mounting accessory. For proper installation it is strongly recom- mended to use a trained, Mitsubishi authorized service person. Fail- ure to follow Mitsubishi standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding your warranty.

When using mounting accessories, other than Mitsubishi compliant and approved, they must be VESA-compatible mounting method. Mitsubishi strongly recommends using screws M4 size and 8mm in length. If using screws longer than 8mm, check the depth of the hole.

(Recommended Fastern Force: 150 ~ 170N•cm)

Mitsubishi recommends using mounting interface that comply with UL1678 standard in North America.

To avoid falling down

Fasten the LCD monitor to a wall using a cord or chain which is suffi- cient to support the weight of the LCD monitor (approx. 31.5kg).

Screw Holes

Cord or Chain

ClamperScrew

Before moving the LCD monitor, the cord or chain should be removed.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents MLM300 Table of Contents Important Information Canadian Department of Communications Compliance StatementSafety Precautions and Maintenance Recommended UseErgonomics Contents Lay the screen face down Ambient temperature should be less than 40 deg CAttaching LCD Options To avoid falling downControl Panel Switches the audio mute ON/OFFRocker Switch for the main power on/off Acts as SET button with on-screen menuParts Name and Functions To output the audio signal from the Audio in 3 jackTo output the audio signal from Audio 1, 2 or 3 jack Terminal PanelWireless Remote Control RGB2DVD/HD Video Other than to install the batteries, do not open the remote Operating Range for the Remote ControlHandling the remote control Avoid exposure to heat and steam 30o 30oSetup Procedure Before making connections Wiring DiagramConnections For PC Audio CableConnecting the LCD Monitor to a PC To audio outputConnecting to a Macintosh Computer Connecting to a Computer with a Digital Output To DVI outputConnecting to a VCR or Laser Disc Player RCAConnecting to a DVD Player Connecting to a Stereo Amplifier Pressing the power button Using the remote control Pressing the Main Power SwitchBasic Operation On-Screen Menu Controls -Computer On-screen Menu Controls Auto Setup Audio ResetConfiguration Auto AdjustAuto Brightness Power SaveOFF Timer LanguageOn-screen Menu Controls -DVD & HD BassConfiguration Reset Noise Reduction On-screen Menu Controls -AV InputTint TrebleRestore to factory defaults Selecting PIP Reset allows you to reset all PIPSettings to factory default position OFF Timer menu, you can select howColor System Using the LCD with a Personal ComputerPC Using the LCD with a Personal Computer Features Troubleshooting References Specifications Input Signal PC Input VideoLimited Warranty Mitsubishi MLM300 MLM300 L30HV201
Top Page Image Contents