Mitsubishi Electronics FFT9905SKJHFW manual Radio Interference Regulations Statement for U.S.A

Page 3

RADIO INTERFERENCE REGULATIONS STATEMENT FOR U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

THIS PRODUCT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS WITH SIGNAL CABLE SC-B102. USE IT TO REDUCE THE POSSIBILITY OF CAUSING INTERFERENCE TO RADIO, TELEVISION, AND OTHER ELECTRIC DEVICES.

NO USER SERVICEABLE PARTS INSIDE. DO NOT ATTEMPT TO MODIFY THIS EQUIPMENT. IF MODIFIED, YOUR AUTHORITY TO OPERATE THIS EQUIPMENT MIGHT BE VOIDED BY FCC.

WARNING!

This product is not designed for use in life support devices and Mitsubishi Electric corporation makes no representations to the contrary. Life support devices are those devices which are used to measure, diagnose, or evaluate the tissue, sys- tems or functions of the human body; or other devices employed to support or sustain life or good health.

MANUFACTURER DECLARATION FOR CE-MARKING:

We, Mitsubishi Electric Corp., declare under our sole responsibillity, that this product is in conformity with the following standards:

EN60950 EN55022 Class B EN50082-1 EN61000-3-2 EN61000-3-3

following the provisions of:

73/23/EEC

Low Voltage Directive

89/336/EEC

EMC Directive

As an ENERGY STAR Partner, Mitsubishi Electric Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency.

2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Mitsubishi Trademark Manufacturer Declaration for CE-MARKING Radio Interference Regulations Statement for U.S.AWhy do we have environmentally-labelled computers? Environmental Requirements Contents Introduction FeaturesSuspend mode Internal Preset Memory CapabilityPower Management Function Stand-by modeCleaning Your Monitor DDCLocation Considerations Screen Position Adjustment UnpackingTilt/Swivel Base Function Controls Quick Operation ChartConnecting to Any IBM VGA Compatible System Connecting the MonitorAC Power Connection Signal Cable ConnectionConnecting to a Unix Workstation & Third Party Graphics Card Case of External Composite Sync Signal Case of Separate Horizontal and Vertical Sync SignalsBNC Connection User Controls Control NamesFunction DIN-8P Serial Interface Connector Signal Input Connector BNCPOSI, SIDE-BOW, KEY STONE, PIN-BALANCE, KEY-BALANCE OSDOn Screen Display FunctionsOperation Indicate input connector Frequency of input signalSIDE-BOW PhaseSize PositionMoire KeystonePIN-BALANCE KEY-BALANCEVIDEO-LEVEL Geometry ResetPOWER-SAVE RotationUSB Port Select Adjust LockPower Save is on or OFF Power SavePower Save is OFF Power Save is onBNC TroubleshootingProblem Items to Check Location LEDSpecifications Appendix Monitor Signal Input Connector DB9-15PSC-B102 Signal Cable 13Multimode Macintosh Adapter AD-A205 settings21Multimode 17Multimode3,4 AD-A205 Mac Adapter settings ChartCP871C144A90
Top Page Image Contents