Setup
Input Format
This function is used in setting the input signals of the input connec- tors.
Normally, this should be set to Auto. When identification is not possible with Auto, make the setting.
Select the item name “Input Format”, press the ENTER button, and the sub menu will open.
Select the connector that is to be changed, and select the setting contents with the SELECT buttons.
[RGB]
This is the signal setting for the RGB connector.
Auto | Automatically identifies the signal. |
RGB | Analog RGB signal is set. |
Component . Component signal is set.
[Video] and [S-Video]
[Video] is the color system setting for the VIDEO connector and
Auto | Automatic identification. |
NTSC | Fixed to the NTSC system. |
NTSC 4.43 .. | Fixed to the NTSC 4.43 system. |
PAL | Fixed to the PAL system. |
PAL M | Fixed to the PAL M system. |
PAL N | Fixed to the PAL N system. |
PAL 60 | Fixed to the PAL 60 system. |
SECAM | Fixed to the SECAM system. |
Presentation Timer
The presentation is given while checking the timer displayed on the screen.
The gauge display allows the remaining time to be known at a glance.
Select the item name “Presentation Timer” and select the setting contents with the SELECT buttons.
Setting contents: Off, 10 min. , 20 min. , 30 min. , 40 min. , 50 min. , 60 min.
To start the timer...
Press the MENU button and open the menu.
The timer display will appear at the lower right and the timer will start. See “Using the Presentation Timer” on Page