Onkyo HTE-V10X, PR-155X, ST-V10X, SWA-V10X Preparing the Remote Controller, Inserting the batteries

DV-S155X-En.book Page 12 Saturday, July 24, 2004 2:20 PM

Preparing the Remote Controller

Inserting the batteries

1 2 3

1Detach the battery cover.

2Insert two size-AA/R6 batteries.

Be sure to match the + and – ends of the batteries with to diagram inside the battery

compartment.

3Attach the battery cover.

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if you do not intend to use the remote controller for a long time.

•Remove dead batteries immediately to avoid damage from corrosion. If the remote con- troller does not operate smoothly, replace both batteries at the same time.

•The batteries should last for about six months, although this will vary with usage.

Using the remote controller

Remote control sensor	Remote control sensor
DV-S155X	Amplifier
	(PR-155X, etc.)

30˚ 30˚

RC-522DV

			(16	feet)
		m
	5
About

30˚ 30˚

RC-568S

			(16	feet)
		m
	5
About

DV-S155X

Point the remote controller toward the remote control sensor.

•Place the unit away from strong light, such as direct sunlight or inverted fluorescent light, which can prevent proper operation of the remote controller.

•Using another remote controller of the same type in the same room or using the unit near equipment that uses infrared rays may cause operational interference.

•Do not put any object (such as a book) on the remote controller. The buttons of the remote controller may be pressed by mistake, which drains the batteries.

•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.

•If there is an obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

12