OTC Wireless manual Installation of WiSER2400.IP Software System Requirements

Page 9

Installation of WiSER2400.IP Software

System Requirements

For using the WiSER2400.IP Wireless Ethernet Adapter’s utilities software, your computer must meet the following minimum requirements:

Windows® 95 (OSR2)/ 98 (SE)/NT/ME/2000/XP

One COM port (with a DB-9 male connector or an appropriate adapter to connect to a DB-9 female connector)

Installation

To install the utility program, simply insert the CD-ROM provided. Copy the “wue101.exe” file to the desired location on your PC.

Note that to use the WiSER2400.IP properly as intended, you must configure the WiSER2400.IP radio to the appropriate IP [Internet Protocol] configurations as your network.

Note: For the utility program to configure or monitor the WiSER2400 radio through a COM port, there must be no another serial (RS232) program that also accesses or control the same COM port.

6

Image 9
Contents 802.11b Wireless Serial Port Adapter WiSER2400.IP User Guide Page Table of Content Introduction Introduction Key Features WiSER2400.IP WiFi RadioInstallation of WiSER2400.IP PowerRS232 Connection Link Yellow Status LED’sPage Installation Installation of WiSER2400.IP Software System RequirementsOverview Diagnostic and Configuration UtilityRadio Status Panel Connection and Overall Status PanelConfiguration Panel Configuration PanelPage RS232 and Wlan Statistics Panel RS232 StatisticsWlan Statistics Security Panel Encryption sub-panelWEP Keys Creation Sub-panel Create WEP Keys with Manual Entries Page UDP/IP Implementation Learning the destination MAC address from ARP packetsOutgoing UDP/IP packet IP Header Incoming UDP/IP packet UDP headerBlank Pages Appear When Open the Utility Program TroubleshootingNo Radio Link No Data Transfer While the Radio Link is GoodRadio Interference Poor Link QualityTechnical Support WiSER2400 Software Appendix a Limited Warranty WiSER2400 HardwareFCC Radiation Exposure Statement FCC ID MKZ0207232XG FCC Rules and Regulations PartPage Glossary