Planar SD2320W manual Connect the cables

Connect the cables

The SD2320W unit comes with one 6-foot DVI cable, one 12-foot DVI cable, and one 14-inch DVI cable.

1.	Plug one end of the 6-foot DVI
	cable into the primary port of
	the dual-channel DVI graphics
	card. Plug the other end into
	the bottom monitor of the
	SD2320W unit.
2.	Plug one end of the 14-inch DVI
	cable into the secondary output
	of the dual-channel graphics
	card. Plug the other end into
	the input port (labeled “IN”) of
	the mirror-flip PCI card.
3.	Plug one end of the 12-foot DVI cable	Short DVI cable installed.
	into the output port of the mirror-flip
	PCI card (labeled “OUT”). Plug the

other end into the top monitor of the SD2320W unit.

The two monitors must be connected with an off-the-shelf video cable to comply with FCC regulations. Ferrite-core interface cables are provided. This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

SD2320W 7 User's Guide