Installing the Display 9
Connecting a Video Device
Use the following instructions if you are hooking up a camera, VCR, or other
1Press the Power/Menu button until the Power ON indicator blinks. After a moment, a No Signal Coming message appears.
2Wait for the No Signal Coming message to disappear, approximately 3 to 5 seconds.
3Press the Power/Menu button to display the VGA → VIDEO menu.
4Press the PLUS or MINUS (
/ 
) control to enter video mode.
5Press the UP (
) arrow to change video modes if you are using an alternate video source.
6Press the PLUS or MINUS (
/ 
) control to select the desired video mode.
Connecting the Optional Touch Screen
If your VitalScreen CSR or VitalScreen CR display has the optional touch screen, connect the display
Do not operate the touch screen with sharp objects, such as a scalpel. Sharp objects can scratch or damage the touch screen. A damaged touch screen may pose a safety hazard.
Mounting the Display
When mounting your display, such as to a wall bracket or an articulated swing arm, make sure the maximum length of the screws inserted into the display mounts is 9 millimeters. Forcing the screws deeper into the mounts and exceeding this maximum length may damage the display.
VS17.4SXAD / CM17.4SXAD