Planar PS466OT, PS4660T and PS5560T user manual Default, Options

Page 45

Advanced Menu

Baud Rate

Smart Light Control

Wake Up From Sleep

Factory Reset

Options: 115200, 38400, 19200, 9600

Default: 19200

Options: Off, DCR, Light Sensor

Default: Off

Allows you to configure the display to “wake up” when it receives a digital signal through the DisplayPort, HDMI or DVI connectors. With VGA Only, the display can only “wake up” by sending an analog video signal through the VGA connector.

Options:

Never Sleep - The display will never enter a power saving mode.

VGA Only - The display will enter a power saving mode if it cannot sync for five minutes with the DisplayPort, HDMI or DVI. If the sync is present, the display will “wake up” again.

VGA, Digital, RS-232 - The display will enter a power saving mode if it cannot sync for five minutes with any source.

Default: VGA Only

Restores all settings to their defaults.

Options: No, Yes

Default: No

PS4660T and PS5560T User Guide

41

Image 45
Contents Page Disclaimer Trademark CreditsTable of Contents Downloading Additional Documentation and Firmware Introduction Safety Precautions Safety InformationImportant Safety Instructions What is Temporary Image Retention? Recommended UsageBurn-In Versus Temporary Image Retention European Union Disposal Information Vesa Mounts, General Description Normal Usage GuidelinesCooling Requirements Ambient Light Recommendations Cleaning the PS4660T/PS5560TPackage Contents Description Quantity Contents of the Accessory Kit PS4660T Front and Side DimensionsPS5560T Front and Side PS4660T RearPS5560T Rear Before You Begin Plan Your InstallationTools/Equipment List Other Things You May NeedPrepare Your Installation Location Name ConnectorConnectivity OSD Keypad OSD Keypad ButtonsKey Descriptions LED Indicators Remote Control ReceiverLED On ConditionUsing the Display in Portrait Mode Using the Remote Control Menu Num Function DescriptionChanging the Remote Control Battery Locking/Unlocking the OSD MenusCont Using the Touch Screen Performing Basic FunctionsClick Tap the screen once Quickly drag your finger flick in a desired direction Multi-Touch Functions Turning the PS4660T/PS5560T On Adjusting the VolumeTurning the PS4660T/PS5560T Off Selecting the Input SourceSubmenu OSD Menu Functions, Video Menus Audio Menu OSD MenusRTC Submenus Basic MenusAdvanced Menu System Menu Navigating Through the Menus Video MenuScheme Brightness Contrast Color Temperature & Gamma Menu Gamma Color TemperatureSharpness Saturation Hue Backlight Color Temp & Gamma Default Default Volume Bass Treble Balance Hdmi Audio Input DP Audio InputDefault Hdmi Range -6~6Basic Menu Basic Menu/RTC Real Time Clock Menu Real Time Timer ModeTimer Mode User mode RTC Timer Mode UserTimer Mode Work Days mode RTC Timer Mode Work DaysTimer Mode All Days mode RTC Timer Mode All DaysOptions No, Yes Default No Auto Adjustment Image Position Phase ClockOptions On Default Off Advanced MenuOptions System Menu Following table shows the default settings for the LCD Default SettingsSignal Compatibility Timing FH KHz FV HzDisplay Port Specification SpecificationsHumidity Issue Check for the following TroubleshootingDocument Name Contents Accessing Planar’s Technical Support WebsiteDownloading Additional Documentation and Firmware Downloading Utility Software