EN
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need to purchase 2 x
Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.
NOTE Do not use rechargeable batteries.
shows when batteries are low.
UNIT | LOCATION |
|
|
Main | Humidity Area when the |
| INDOOR humidity is |
| shown. |
|
|
Remote | Humidity Area when the |
| OUTDOOR humidity is |
| shown. |
|
|
6
CHANGE SETTINGS
1.Press and hold MODE for 2 seconds to enter setting mode.
2.Press UP or DOWN to change settings.
3.Press MODE to confirm.
TABLE STAND OR WALL MOUNT
Insert the stand on the back of the product, or mount it on a wall with a nail.
REMOTE SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/ Hygro Sensor that collects Temperature and Humidity data. Data can be collected from up to 3 sensors. Additional sensors sold separately.
RMR603HGA lab test R2 | 6 | 1/17/04, 4:52 PM |