Oregon Scientific BAR623PA user manual Search for Sensor, Turn Atomic Clock Signal on / OFF

EN

SEARCH FOR SENSOR

To search for the sensor, press and hold SEARCH (on the main unit) for 2 seconds.

NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location.

NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. This is normal and does not affect general product performance. The reception will resume once the interference ends.

CLOCK

The clock automatically synchronizes the current time and date when it is brought within range of the WWVB- 60 atomic clock signal generated from Fort Collins, Colorado. For more information, please visit: http://www. boulder.nist.gov/timefreq/stations/radioclocks.htm

NOTE The signals are collected by the main unit when it is within 932 miles (1500 km) of a signal.

Initial reception takes 2-10 minutes, and is initiated when you first set up the unit, and whenever you press RESET.

Once complete, the reception icon will stop blinking. The icon is shown in the Clock Area.

STRONG SIGNAL WEAK SIGNAL NO SIGNAL

To force a manual search for atomic clock signals, press and hold for 2 seconds. If no signal is found, check the batteries.

TURN ATOMIC CLOCK SIGNAL ON / OFF

Perform this step if you cannot receive atomic clock signals. Press and hold for 2 seconds. Then, manually set the clock following the “Set Clock” instructions.

The signal icon indicates that the clock feature is ON. No icon means that it is OFF.

10