Audio Adjust
1 | 2 | 3 | 4 | 5 | 6 |
Menu | Audio Adjust |
With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.
Multiplex/Mono
■Multiplex
Input Ch (Mux)
`Main
`Sub
`Main/Sub
This setting determines which channel of a stereo multiplex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.
■Mono
Input Ch (Mono)
`Left + Right
`Left
`Right
This setting specifies the channel to be used for playing any
Dolby
■PL II Music (2ch Input)
These settings apply to only
Panorama
`On
`Off
With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic II Music listening mode.
Dimension
`
With this setting, you can move the sound field forward or backward when using the Dolby Pro Logic II Music listening mode. Higher settings move the sound field backward. Lower settings move it forward.
If the stereo image feels too wide, or there’s too much surround sound, move the sound field forward to improve the balance. Conversely, if the stereo image feels like it’s in mono, or there’s not enough surround sound, move it backward.
Center Width
`0 to 3 to 7
With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic II Music listening mode. Normally, if you’re using a center speaker, the center channel sound is output from only the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front left and right speakers to create a phantom center). This setting controls the front left, right, and center mix, allowing you to adjust the weight of the center channel sound.
Advanced Operations
DTS
■Neo:6 Music
Center Image
`0 to 2 to 5
With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel.
Changing the value from “0” to “5” will spread the sound of the center channel to left and right (outwards).
Theater-Dimensional
■Listening Angle
`Wide:
Select if the listening angle is 40 degrees.
`Narrow:
Select if the listening angle is 20 degrees. With this setting, you can optimize the Theater- Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings.
Front left speaker | Front right speaker |
| 20°/40° |