Optoma Technology HD66 manual Regulation & Safety notices

Page 54

Appendices

Regulation & Safety notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

English 54

Image 54
Contents Table of Contents Safety Information Usage NoticePrecautions Do not Eye Safety Warnings Product FeaturesPackage Overview DocumentationProduct Overview Main UnitControl Panel Input / Output Connections Remote Control Installation Connecting the ProjectorConnect to Video Sources Powering the projector On/Off Powering On the ProjectorPower/Standby  Lens Cap Powering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting the Projector’s Zoom / Focus Adjusting Projection Image SizeUser Controls Four Directional Select Keys KeystoneRemote Control Freeze AV mute Video VGAHow to operate On-screen Display MenusMenu Tree Display Mode BrightnessSaturation ContrastSharpness TintBrilliantColor Image AdvancedDegamma Color TempAdvanced Input Source Advanced Color SettingsReset ColorDisplay FormatInput Signal Display on Screen Image Shift OverscanZoom KeystoneSetup Language LanguageSetup ProjectionProjector ID VolumeMenu Location MuteFrequency Setup SignalPhase PositionSetup Security Security TimerSecurity Change Password Setup Advanced LogoLogo Capture Information Hide Source LockHigh Altitude Keypad LockSleep Timer min Direct Power OnAuto Power Off min Power Mode StandbyLamp Reset Lamp SettingsBrightness Mode Lamp HoursImage Problems No image appears on-screenPartial, scrolling or incorrectly displayed image Image is unstable or flickering Image has vertical flickering barImage is too small or too large Image is stretched when displaying 169 DVD titleImage is out of focus Image has slanted sidesProjector stops responding to all controls Other ProblemsProjector Status Indication Lamp burns out or makes a popping soundRemote Control Problems If the remote control does not workOn Screen Messages Replacing the lamp Lamp Replacement Procedure Compatibility Modes  Computer Compatibility Video Compatibility RS232 Commands RS232 Commands RS232 Protocol Function ListSend to emulate Remote Ceiling Mount Installation Optoma Global Offices USAKorea Regulation & Safety notices Remarque à l’intention des utilisateurs canadiens