Installation
Powering the projector On/Off
Powering On the Projector
. Remove the lens cap.
2.Securely connect the power cord and signal cable. When connected, the Power LED will turn red.
3.Turn on the lamp by pressing “POWER” button either on the top of the projector or on the remote. The Power LED will now turn Green.
The startup screen will display in approximately 0 seconds.
The fi rst time you use the projector, you can select your preferred language after the startup screen displays.
4.Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. If not, push menu button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the “SOURCE” button on the control panel or direct source keys on the remote control to switch between inputs.
Turn on the projector fi rst and then select the signal sources.
2Power/Standby
Lens Cap
3 English