Optoma Technology EP783, TX783RFBA manual Ceiling Mount Installation

Page 61

Appendices

Ceiling Mount Installation

1.To prevent damaging your projector, please use Optoma’s recommended mount package for installation.

2.If you wish to use a third party ceiling mount kit, please ensure the screws used to attached a mount to the projec- tor met the following specifications:

Note

Please note that damage result- ing from incorrect installation will

Screw type: M6

Maximum screw length: 8.5mm

Minimum screw length: 6.5mm

Unit: mm (millimeter)

invalidate the warranty.

Warning:

1. If you buy the ceiling

mount from other

company, please

ensure that there is at

least 10cm distance

between the bottom

cover of the projector

811

Fixed distance

in M 004

Adjustable distance

xa M 085

and the ceiling.

2. Avoid placing

the projector near

sources of heat such

air-conditioning

units and heaters

otherwise it may

overheat and shut

down automatically.

Front of projector

912.5 652 .5 574

229 169

30

161

.5 001 .5 601

3. Ceiling mounting

shall be mounting on

metal or concrete.

114140

398

Engli

61

s

h

Image 61
Contents Table of Contents Usage Notice Safety InformationPrecautions Don’t Eye Safety Warnings Introduction Product FeaturesDocumentation Package OverviewMain Unit Product OverviewControl Panel Connection Ports Remote Control with Mouse Function and Laser Pointer Connect to Computer/Notebook Connecting the ProjectorOte Connect to VideoPowering On the Projector Powering On/Off the ProjectorPowering off the projector Adjusting the Projected Image Adjusting the Projector’s Zoom / Focus Vertical Direction Horizontal Direction Lens Shift Range Adjusting Projection Image SizeUser Controls Control Panel & Remote ControlUsing the Remote Control Keystone VGA-1 Using the USB Remote Mouse ControlOn-Screen Display Menus Menu Tree Image Display ModeBrightness ContrastImage Color Degamma Image AdvancedWhite Peaking Color TempInput Source Color SpaceEdge Enhancement Image Advanced Color EnhancementColor Vividness ExtensionFormat DisplayInput Signal Overscan PC ModeZoom Image ShiftKeystone Display KeystoneHeight of Image Language Setup LanguageProjection SetupMenu Location MuteRS232 VolumeProjector ID Phase Setup SignalFrequency PositionSecurity Timer Setup Security SettingSecurity First Time Change PasswordLogo Setup AdvancedLogo Capture Lens Shift Setup Lens FunctionZoom/Focus IP Address Setup NetworkSubnet Mask GatewayHow to use web browser to control your projector 10.0.50.100 User Controls Options Signal Power On Direct Power OnAuto Power Off Sleep TimerBrightness Mode Options Lamp SettingsLamp Reset Lamp HoursAppendices Image is unstable or flickering Image is reversed Intermission Problems Remote Control Problems Appendices Replacing the lamp Lamp Replacement Procedure  Video Compatibility  Computer CompatibilityRS232 Pin Assignments RS232 Commands and Protocol Function ListSend to projector RS232 Protocol Function ListSend to Remote Ceiling Mount Installation USA Optoma Global OfficesKorean Regulation & Safety notices Remarque à l’intention des utilisateurs ca- nadiens