Appendices
The image
is
stretched when displaying 16:9 DVD title
When you play anamorphic DVD or 16:9 DVD, the projector will show the best image in 16:9 format in OSD. If you play 4:3 format DVD title, please change the format as 4:3 in projector OSD. If the image is still stretched, you will also need to adjust the aspect ratio by referring to the following:
4Please setup the display format as 16:9 (wide) aspect ratio type on your DVD player.
Image is
too small
or too large
4 Adjust the Zoom Ring on the top of the projector.
4 Move the projector closer to or further from the screen.
4 Press [Menu] button on the remote control or projector panel, go to Display 
Format
and try the different settings.
Image has slanted sides
4 If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen.
4 Press [Keystone
Image is
reversed
4 Select Setup 
Projection from the OSD and adjust the projection direction.
Other
The projector stops responding to all
controls
4 If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.
Lamp
burns out or makes a popping sound
4 When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the
projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in Replacing the Lamp on page 56.