Installation
When Power mode (Standby) is set to Eco (<0.5W), the VGA output and Audio pass- through will be deactivated when the projector is in standby.
Powering the projector On / Off
Powering On the Projector
1.Remove the lens cap. (optional)
2.Securely connect the power cord and signal cable. When connected, the POWER/STANDBY LED will turn Amber.
3.Turn on the lamp by pressing “
” button either on the top of the projector or on the remote. The POWER/STANDBY LED will now turn Green.
The startup screen will display in approximately 10 seconds. The first time you use the projector, you will be asked to select the preferred language and power saving mode.
4.Turn on and connect the source that you want to display on the screen (computer, notebook, video player, etc). The projector will detect the source automatically. If not, push menu button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the “SOURCE” button on the control panel or direct source keys on the remote control to switch between inputs.
2 POWER/STANDBY
/
Turn on the projector first and then select the signal sources.
1 Lens Cap (optional)
13English