Installation
Powering Off the Projector
1.Press Power to turn off the projector lamp, a message displays on the projector’s screen.
2.Press Power again to confirm, otherwise the message disappears after 15 seconds.
3.The cooling fans continue to operate for about 10 seconds for cooling cycle.
(If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press Power to restart the projector.)
4.Turn off the main power switch. Disconnect the power cord from the electrical outlet and the projector.
5.Do not turn on the projector immediately following a power off procedure.
Warning Indicator
vWhen the POWER LED indicator repeatedly blinks four (4) times, the projector will automatically shut itself down. Please contact your local reseller or service center. See pages 52.
vWhen the TEMP LED is on a steady (not flashing) red, the projector will automatically shut itself down. Under normal conditions, the projector can be switched on again after it has cooled down. If the problem persists, you should contact your local dealer or our service center. See pages 52.
vWhen the LAMP LED is on a steady RED (not flashing), it indicates the lamp system failed. Please contact your local dealer or our service center. See pages 52.
English 16