Optoma Technology TX330 manual Regulation & Safety notices

Page 49

Appendices

Regulation & Safety notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this projector.

49 English

Image 49
Contents Table of Contents Important Safety Instruction Safety InformationsClass B emissions limits Precautions Don’t Eye Safety Warnings Introduction Documentation Package OverviewMain Unit Product OverviewControl Panel Connection Ports Remote Control Connecting the Projector InstallationPowering On the Projector Powering On/Off the ProjectorPower Lens CapPowering off the projector Adjusting the Projector’s Height Adjusting the Projected ImageAdjusting Projection Image Size Adjusting the Projector’s Zoom / FocusKeystone Adjust image distortion caused by tilting Control Panel & Remote ControlEnter Four DirectionalButton LaserPC/ Mouse ControlFour Direc VideoTional Select Keys VideoOn-screen Display Menus How to operateMenu Tree Image Display ModeBrightness ContrastColor Image ColorDegamma Image AdvancedWhite Peaking Color TempInput Source Enable input sources. Press into the next menu as belowFormat DisplayInput Signal Zoom OverscanImage Shift KeystonePC Mode Language SetupMenu Location ProjectionPhase Setup SignalFrequency PositionSecurity Timer Setup SecuritySecurity First Time Change PasswordOptions Auto Power Off min Direct Power OnSleep Timer min Options AdvancedOptions Lamp Settings Image Problems TroubleshootingNo image appears on-screen Partial, scrolling or incorrectly displayed imageImage has vertical flickering bar Image is unstable or flickeringImage is out of focus Image is stretched when displaying 169 DVD titleImage is too small or too large Image has slanted sidesProjector Status Indication Intermission ProblemsProjector stops responding to all controls Lamp burns out or makes a popping soundMessage Reminders If the remote control does not work Remote Control ProblemsReplacing the lamp Lamp Replacement Procedure  Computer Compatibility Compatibility Modes Video Compatibility Optoma Global Offices Korean Regulation & Safety notices Remarque à l’intention des utilisateurs canadiens