Appendices
Intermission Problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 60 seconds before reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp, follow the procedures in the “Replacing the Lamp” section on pages
Projector Status Indication
LED lighting message
Message | Power LED | |||
(Green/Amber) | (Red) | (Red) | ||
| ||||
Standby State | Flashing |
|
| |
(Input power cord) | Amber |
|
| |
Power on (Warming) | Flashing |
|
| |
Green |
|
| ||
|
|
| ||
Lamp lighting | Green |
|
| |
Error (Over Temp.) |
|
|
| |
Error (Fan fail) |
| Flashing |
| |
| (0.25s on, 0.25s off) |
| ||
|
|
| ||
Error (Lamp fail) |
|
|
| |
Steady light | No light |
| ||
English 44