Optoma Technology EP728, EP727, EP723, EP721 manual Regulation & Safety notices

Page 56

Appendices

Regulation & Safety notices

This appendix lists the general notices of your projector.

FCC notice

This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the device and receiver.

Connect the device into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Notice: Shielded cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Caution

Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this computer.

English 56

Image 56
Contents Table of Contents Class B emissions limits Safety InformationsImportant Safety Instruction Precautions Don’t Eye Safety Warnings Introduction  Video Compatibility NTSC, NTSC4.43Package Overview DocumentationProduct Overview Main UnitControl Panel Connection Ports Remote Control Installation Connecting the ProjectorConnect to Video Sources Lens Cap Powering On/Off the ProjectorPowering On the Projector Powering off the projector Adjusting the Projected Image Adjusting the Projector’s HeightAdjusting the Projector’s Zoom / Focus Adjusting Projection Image SizeControl Panel & Remote Control Temp LED Indicate the projector’s temperature statusFour Directional Select KeysLaser PC/MouseControl ButtonRemote Control VideoHow to operate On-screen Display MenusMenu Tree Display Mode ImageBrightness ContrastSaturation TintColor ResetImage Color Image Advanced DegammaBrilliantColorTM Color TempInput Source Display FormatInput Signal Overscan ZoomImage Shift KeystoneSetup Language LanguageSetup ProjectionProjector ID Information HideStart Up Logo Security Setup SecuritySecurity Timer Change Password First TimeSetup Signal PhaseFrequency PositionOptions Volume Sleep Timer min Direct Power OnAuto Power Off min Options Lamp Settings Brightness ModeLamp Reset Lamp HoursTroubleshooting Image ProblemsNo image appears on-screen Partial, scrolling or incorrectly displayed imageImage is unstable or flickering Image has vertical flickering barImage is stretched when displaying 169 DVD title Image is out of focusImage is too small or too large Image has slanted sidesIntermission Problems Projector Status IndicationProjector stops responding to all controls Lamp burns out or makes a popping soundMessage Reminders Remote Control Problems If the remote control does not workReplacing the lamp Lamp Replacement Procedure  Video Compatibility Compatibility Modes Computer Compatibility RS232 Commands RS232 Commands RS232 Protocol Function ListFunction Projector Return Description Ceiling Mount Installation Optoma Global Offices Korean Regulation & Safety notices Remarque à l’intention des utilisateurs canadiens