Optoma Technology EP718 specifications Installation, Connecting the Projector to Desktop Computer

Page 9

9

English

Installation

Connecting the Projector to Desktop Computer

1.Make sure the projector and your computer are turned off.

2.Connect one end of the projector signal cable to the projector; connect the other end to the VGA connector on the computer and tighten the screws.

3.Connect one end of the power cord into the back of projector; connect the other end to an electrical outlet.

4.The adapter of remote receiver is connected to RS232C socket at the back of the computer.

Computer Output

RS232C

VGA Cable

 

Power Cord

Remote Receiver Cable

 

vTo ensure the projection display works well with your computer, please configure the display mode of your graphic card to make it less than or equal to 1024 X 768 resolution. Make sure timimg of the display mode is compatible with the projection display. Refer to the“Compatibility Modes”section on page 28.

Image 9
Contents Table of Contents Usage Notice PrecautionsIntroduction Product FeaturesPackage Overview Main Unit Product OverviewPanel Control Connection PortsRemote Control Laser Point Connecting the Projector to Desktop Computer InstallationConnecting the Projector to Portable Computer If you use the video cable Connecting the Projector to Other Video SourcesIf you use the s-video cable Powering On the Projection Display Power On/Off the Projection DisplayPowering Off the Projection Display Adjusting the Projector Height Adjusting the Projected ImageAdjusting the Projector Focus User Controls PIP Computer mode only VolumeReset Zoom In Computer mode onlyOSD Menus 4Color Video mode only 4Tint Video mode only4Volume 4Tracking44 3 Video mode only 416 9 Video mode only4PIP Computer mode only 4Treble4Reset All 4Lamp Reset4Lamp Warning 4Exit MenuProblem No image appears on screen Problem Partial, scrolling or incorrectly displayed imageAppendices Problem Image is unstable or flickering Problem Image has vertical flickering barProblem Image is out of focus Problem The screen is outstretched when displaying 169 DVD To replace the lamp module, reverse the previous steps Lamp Changing ProcedureSpecifications Compatibility Modes