TROUBLESHOOTING GUIDE
START UP PROBLEMS | • | If the image is too small or too large: | |
• If no lights or sounds turn on: |
| – Move the projector closer to or farther from the | |
– Be sure that the power cord is securely connected to |
| viewing surface. | |
the projector and the other end is plugged into an | • | If the projector colors seem slightly wrong: | |
outlet with power. | |||
| – Go to the main menu and try adjusting the Color, | ||
– Be sure the lens cap is off. |
| ||
| Tint, Brightness and Contrast of the picture. | ||
– Press the On/Off button again. |
| ||
INTERRUPTION PROBLEMS | |||
– Unplug the power cord for 15 seconds, then plug it | |||
in and press the On/Off button again. | • | If the projector stops responding to all controls: | |
– Be sure volume is turned up. |
| – If possible, turn off the projector, then unplug the | |
PICTURE PROBLEMS |
| power cord and wait at least 15 seconds before | |
| reconnecting power. | ||
• If the image is out of focus: | • | If the lamp shuts off during a show: | |
– When displaying the main menu, adjust the manual | |||
| – A minor power surge might cause the lamp to shut | ||
focus. |
| ||
| off. This is normal. Wait a few minutes, then power | ||
– Ensure the projection surface is between 4 and 8 |
| ||
| on the projector. | ||
feet away from the projector. |
|
| |
–Check the projection lens to see if it needs cleaning.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. | Product and colors may vary. | |
- Increase the separation between the equipment and the receiver. | © 2005 Hasbro. All Rights Reserved. | |
- Connect the equipment into an outlet on the circuit different from that to which the receiver is connected. | TM & ® denote U.S. Trademarks. | |
- Consult the dealer or an experienced radio/TV technician for help. | 75052 | PN 6515800000 |