Shutting down the projector

The projector automatically displays a black screen after no active source is detected for 30 minutes. This black screen helps preserve the life of the pro- jector. The image returns when an active source is detected or a remote or keypad button is pressed.

Screen Save

You can make the black screen appear after a preset number of minutes by turning on the Screen Save feature in the Settings>System menu. See page 38.

Power Save

The projector also has a Power Save feature that automatically turns the lamp off after no active sources are detected and no user interaction with the projector is performed for 20 minutes. By default, this feature is off. See page 38.

Turning off the projector

You can turn the projector off simply by toggling the power switch to the off position.

You can also press the remote’s Power button to place the projector in the Off state while it is running. When the Power button is pressed twice (once to start the power-down process and a second time to verify that you want to power the projector off), the lamp turns off and the LED blinks green for one (1) minute while the fans continue to run to cool the lamp. While the LED is blinking green, the projector does not accept any keypad and remote control input.

When the lamp has cooled, the LED lights solid green and the fans slow down to minimal speed. To turn off the projector, toggle the power switch to the off position.

NOTE: Once the projector has been toggled off, you must wait for one (1) minute before turning the projector on again. This allows the lamp to prop- erly cool. However, if the remote was used to power the projector to the Off state you do not need to wait one minute to turn it on again.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section. If it does not, troubleshoot the setup.

The LED on top of the projector indicates the state of the projector and can help you troubleshoot.

Table 1: LED behavior and meaning

LED color/behavior	Meaning

solid green	The power switch has been toggled on
	and the software has initialized or the pro-
	jector has been powered off via the
	remote.

blinking green	The power switch has been toggled on
	and the software is initializing, or the pro-
	jector is powering down and the fans are
	running to cool the lamp.

blinking red	A fan or lamp failure has occurred. Make
	sure the vents aren’t blocked (see
see page 44 for more information	page 27). Turn off the projector and wait
	one minute, then turn the projector on
	again. If the projector has been working
	exceeded its lamp life (page 41), replace
	the lamp and reset the lamp timer. Con-
	tact Technical Support if the problem per-
	sists.

solid red	An unidentifiable error: please contact
	Technical Support.

The following tables show common problems. In some cases, more than one possible solution is provided. Try the solutions in the order they are pre- sented. When the problem is solved, you can skip the additional solutions.