Appendix
Red LED behavior and projector errors
If the projector is not functioning properly and the LED is blinking red, con- sult Table 4 to determine a possible cause. There are
| Table 4: LED Behavior | |
|
|
|
Red LED Behavior |
| Explanation |
|
|
|
One (1) blink |
| The lamp won't strike after five (5) |
|
| attempts. Check the lamp and lamp door |
|
| installations for loose connections. |
|
|
|
Two (2) blinks |
| The lamp counter hours have exceeded |
|
| lamp life hours. Replace the lamp and |
|
| reset the lamp hours counter. |
|
|
|
Three (3) blinks |
| The projector has shut down. Check to |
|
| see if the lamp door is open. If the lamp |
|
| door is closed, toggle off the projector |
|
| and wait one minute, then toggle the pro- |
|
| jector on again. If the lamp does not strike |
|
| after one minute, replace the lamp. Con- |
|
| tact Technical Support for repair if replac- |
|
| ing the lamp does not solve the problem. |
|
|
|
Four (4) blinks |
| The fan has failed. Contact Technical Sup- |
|
| port for repair or replacing the fan. |
|
|
|
Five (5) blinks |
| The projector is overheating. Check for a |
|
| blocked air vent (page 16). Contact Tech- |
|
| nical Support for repair if clearing the |
|
| vents/screens does not solve the problem. |
|
|
|
32