InFocus INF7011 manual Using the Remote

Using the Remote

The remote uses two (2) AAA batteries (not included). Install the batteries by removing the cover from the remote’s back, aligning the + and – ends of the batteries, sliding them in place and replacing the cover.

To operate, point the remote at the monitor sensor at the bottom right-hand corner of the monitor. The range of optimum operation is about 26’ (8m) and within a horizontal and vertical angle of 30 degrees.

30˚

30˚

i

CAUTION:

•When disposing of the batteries, be sure to do so in an environmentally proper manner.

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•Ensure the batteries’ polarity (+/-) is properly aligned.

•Do not mix new and old batteries or different types of batteries together.

•Replace the batteries as soon as they run out.

•Remove batteries from the remote control when storing or not in use for a prolonged period.

INF7011 Hardware Guide Page 11