Cleaning the dust filter
1Turn off the projector and unplug the power cable.
2Wait 60 minutes to allow the projector to cool thoroughly.
WARNING: To avoid burns, allow the projector to cool for at least 60 minutes before you clean or replace the dust filter.
3Turn the projector upside down and remove the lamp door. See page 38.
4Press the tab on the dust filter and lift it off.
5Clean the filter using a vacuum set on low power.
6Replace the dust filter and the lamp door.
I O
trigger
network mouse USB | computer 1 | computer 2 | monitor out |
| |||
|
| computer 3 | serial control |
|
| computer in |
|
turn off and unplug the projector
wait 60 minutes
Using the security lock
The projector has a security lock for use with a cable lock system. See “Accessories” on page 41 for ordering information. Refer to the information that came with the lock for instructions on how to use it.
|
| audio in |
|
|
|
| R |
| trigger |
network PS/2 | USB | computer 1 | computer 2 | monitor out |
|
| |||
|
| L |
|
|
|
| audio in | computer 3 | serial control |
I |
| computer in |
|
|
|
|
|
|
O
security lock
40