OPERATIONS
|
| STANDBY/ | STANDBY/ON | VIDEO | |
|
|
| |||
POWER Indicator | STANDBY/ON Button | ON Button | LASER |
| |
BLANK | RGB | ||||
|
|
| |||
FOCUS button | ZOOM button |
|
| ||
|
|
|
| ||
|
|
| AUTO |
| |
|
|
| MENU | POSITION | |
|
|
| MENU SELECT | ||
Power Switch |
|
| PinP | RESET | |
|
| FREEZE |
| ||
|
|
|
| ||
|
|
| MAGNIFY | VOLUME | |
|
| FOCUS button | OFF |
| |
|
|
| MUTE | ||
|
|
| FOCUS ZOOM |
| |
| Lens cap | ZOOM button |
|
| |
ENGLISH
Power ON
1.Check that the power cord is connected correctly.
2.Set the power switch to [ ]. The standby mode is selected, and the POWER indicator is turned to orange.
3.Press the STANDBY/ON button 
on the control panel or the remote control transmitter.
4.The POWER indicator ceases blinking and turns to green when power is on. Remove the lens cap.
5.Adjust picture size using the ZOOM button.
6.Adjust focus using the FOCUS button .
Power OFF
1.Press the STANDBY/ON button 
on the control panel or the remote control transmitter for approximately 2 seconds. The projector lamp is extinguished and lamp cooling begins. The
POWER indicator blinks orange during lamp cooling. Pressing the STANDBY/ON button 
has no effect while the POWER indicator is blinking.
2.The system assumes the Standby mode when cooling is complete, and the POWER indicator ceases blinking and changes to orange. Check that the indicator is orange and set the Power switch to [O].
3.The POWER indicator is extinguished when power is off. Attach the lens cap.
WARNING • Please read this manual, and the separate “SAFETY INSTRUCTIONS” thoroughly before using the equipment. Always ensure that
the equipment is used safely.
NOTE • Except in emergencies, do not turn off unless the POWER indicator is orange as it will reduce the life of the projector lamp.
•To prevent any troble, turn on/off the projector when the computer or video tape recorder is OFF. Providing a