InFocus 760 manual Connecting the LitePro

Page 19

Connecting the LitePro 760

Connecting an HP, DEC or IBM Workstation or

Tektronix X Terminal

Follow this procedure if your computer is an HP workstation or X terminal, an IBM RS6000/220, a DEC VAXstation or DECstation 3100 or a Tektronix X terminal.

1.Locate your monitor cable; it connects the monitor to the com- puter. Unplug it from the computer. Remember where you unplugged the cable from the computer, you will plug the LitePro cable into this same connector in the next step.

2.Attach one of the BNC adapters to the “Computer” end of the LitePro cable. Plug the adapter (with the cable attached) into the monitor connector on the computer.

3.Attach the other BNC adapter to the “Monitor” end of the LitePro cable. Plug the adapter (with the cable attached) into the com- puter’s monitor cable.

4.Tighten the thumb screws on all the connectors to ensure proper grounding.

5.Turn on the monitor.

6.Turn on the LitePro 760 by pressing the “1” side of the power switch. (Refer to “Powering Up the LitePro” on page 15.)

7.Turn on the computer.

10	LitePro 760 User’s Guide

Image 19

Contents Fold and tear here BNC If your computer isPage Trademarks Safety CertificationsFCC Warning Instructions to UserPage Power Source Safety SummaryPower Cord Hot Surfaces GroundingFuse LampContents Page Introduction Shipping Box ContentsCables and Adapters CompatibilityIf You Need Assistance Usage Guidelines31 0 Page Setting Up Connecting the LiteProT e P r o T i p s If Your Computer is You will use Turn to Connecting your ComputerConnecting a Sun, SGI, Intergraph or NeXT Workstation Connecting the LitePro LitePro 760 User’s Guide Connecting the LitePro Connecting the LitePro Connecting a Macintosh Connecting an IBM-Compatible Laptop Computer or SPARCbook Connecting a Macintosh PowerBook Turning the LitePro Off Powering Up the LiteProPage Using the Remote Control Using the LiteProFocusing the Image Adjusting the Height Arrow buttons Reference to the Remote Control ButtonsMenu StandbyBrightness ContrastSync Displaying the Menu Using the MenuSelecting and Adjusting Menu Functions Returning to Default SettingsGreen Menu FunctionsTechnical Information RedColors TrackLanguage Rear ProjectionReset Switching Projection LampsUsing the LitePro Page Cleaning the Lens MaintenanceReplacing the Projection Lamps Lamp Bulb Guard Replacing Batteries in the Remote ControlReplacing the Fuse Maintenance Maintenance Page Before You Call for Assistance TroubleshootingProblem Nothing on screen Solutions to Common ProblemsProblem Color or VGA text not being projected Problem Image is out of focus Problem Image is not centered on the screenProblem Only the test pattern is displayed Problem Image is too wide or narrow for screenProblem Projected colors don’t match the monitor’s colors Problem Image and menus are reversed left to rightProblem LitePro displays vertical lines, bleeding or spots Problem Image is noisy or streakedCompatibility and Cabling AppendixSystem Resolution Specifications Altitude TemperatureDimensions WeightCompatible Product AccessoriesStandard Accessories ship with LitePro Part Number Power Cords one ships with LitePro, depends on countryLCD Connector Cable Connector Pin AssignmentsInput Pin Signal Description Output Pin Pin Monitor and Computer ConnectorsKey command to Computer Activate port De-activate port Portable and Laptop Activation ChartNCR Appendix Numerics IndexCables Index Quadra, see Macintosh MacintoshIndex Limited Warranty Part Number