Onkyo Controlling Components That Are Out of Range, Controlling the T-4555P When It’s Out

T-4555P_En.book Page 18 Wednesday, August 9, 2006 3:42 PM

Connecting the T-4555P—Continued

Controlling Components That Are Out of Range

You can use the following multi-room kits to control the T-4555P when it’s out of range of the remote controller:

•Multiroom AV distribution and control systems such as those made by Niles® and Xantech®.

Controlling Other Out-of-range

Components

If another component is out of range of its remote con- troller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the T-4555P’s IR IN, as shown below.

Connecting block

IR IN

IR receiver

	IR OUT	T-4555P
		IR emitter
		Remote controller
Controlling the T-4555P When It’s Out of		Other
Range
		component
If the T-4555P is located in another room, installed in a		: Signal flow

cabinet, or out of range of its remote controller, you can
use a commercially available IR receiver to pickup the	Connect the IR emitter to the T-4555P’s IR OUT, and
remote controller signals and feed them to the T-4555P,
	place the IR emitter in front of the other component’s
as shown below.
	remote control sensor (usually located on its front
	panel), as shown below. See the instructions supplied
	with the IR emitter.

IR IN

T-4555P

Connecting block

IR receiver

	Other component
	Remote control
from connecting block	sensor
	IR emitter
Miniplug cable

Inside cabinet

Remote controller

Miniplug

: Signal flow

Connect the IR receiver to the T-4555P as shown below.

from connecting block

IR Emitter

T-4555P

:Signal flow

Miniplug cable

Only remote controller signals received by the T-4555P’s IR IN are fed through to the IR OUT. Signals picked up by the T-4555P’s remote control sensor are not output.

T-4555P

18