Warnings and restrictions
•Read all of the included documentation before attempting to install and use the scanner.
•Do not touch the originals and/or the original holder while scanning.
•Do not start scanning or previewing until an original holder with an original has been mounted.
•The original holder is only to be mounted or removed when the drum is in the load position.
•When you turn on the scanner, the drum will roll to the load position, if it is not there already. Do not touch the scanner while the drum is rotating.
•Do not place your fingers or any other object into the scanner while it is connected to power.
•Before servicing or opening the scanner, the power supply must be disconnected from the mains (unplugged). It is not sufficient simply to press the on/off button.
•Install the scanner in a location where children can not get to it. It contains small openings and moving parts that can cause injury.
System requirements
Below are the basic hardware requirements for the PC or Macintosh system to which the scanner is to be connected. For information about the processor, operating system, RAM and harddisk requirements please refer to the “Software Reference” manual, that comes with the FlexColor software.
•Screen resolution of minimum 800 x 600 pixels with true colors
•Mouse or other pointing device.
•FireWire interface.
Preventive maintenance
All Flextight scanners should be serviced every 25,000 scans or every 12 months, whichever comes first. If a Feeder is mounted, the recommended number of scans is 15,000 provided that the feeder is mounted for all scans. Please note that previews are also counted as scans.
Newer Flextight scanners have a counter installed so that the number of scans can be monitored from FlexColor. Please refer to the FlexColor manual to learn more about monitoring the number of scans.
Failures or faults originating from lack of service and/or daily maintenance are not covered by the factory warranty.
4