Hardware Reference - Flextight 646 | 19 | |
Operating the Scanner | ||
|
8.Lift the top layer of the original holder and place your original as follows:
•For transparencies, place your original (G) with the emulsion side down. The original must completely fill the hole with no edges showing and with a minimum overlap of 2mm along each edge. Also, no edges of the original must extend past the outer edges of the holder. Use the grid in the light area (B) of the feed table (A) to help line up the image.
•For reflectives, make sure that no part of the original (M) extends past the edge of the holder. Use the dotted lines printed on the holder to line up the image. Handle the clear plastic layer only by the edges to avoid fingerprints. Curl the plastic layer back and slip the front edge into Flextight's foil holder.
9.Lay the top layer of the holder down flat over the original.
•For transparency holders (H), the top layer (D) is magnetic, which will hold the original in place.
•For the reflective holder (L), note the four metal pegs (the top two are shown as A and C in Figure 7 below); make sure that the clear plastic sheet is pressed all the way down over all four pegs. Note also the two curved tabs at the top of the holder (B in the figure below); the clear sheet must slip under each of these tabs, as shown.
A |
| B |
| C | ||
|
|
|
|
|
|
|
English
Figure 7: Reflective holder, top
10.Go to your computer and follow the directions given in the FlexColor software manual to take a preview, make settings, and take the final scan.