Q:How do I determine the Bluetooth Device Address (BDA) of my hardware device and the version number of both the Bluetooth Specification and the Link Manager Protocol (LMP)?
A:Open the Bluetooth Configuration Panel and click the Hardware tab. Then you could see the Device Address. There you will see the BDA of the selected Bluetooth device and the version number of both the Host Controller Interface and the Link Manager Protocol.
Q: How do I test a Network Access connection?
A:If the client is hardwired to the LAN, simply unplug the hardwired connection to ensure that the test checks the wireless connection rather than the hardwired connection. If the server has access to the Internet, open a browser on the client device(after connecting to Server’s network access service) and connect to the World Wide Web. You may also Ping the server from the DOS prompt.
Q:Why do I get an “Unknown Port” message when I attempt to use a Bluetooth Serial Port?
A:The unknown Port error message usually means that an attempt was made to connect to a port that was in use. Additional Bluetooth Serial Ports can be added if they are required.
Q:What can I do when uninstalling BTW cannot be completed, due to reasons such as electricity stops?
A:Using
Q:What can I do when functions don’t run normally?
A:
Q: How to turn off warning message during installation under Window XP?
A:Perform the following before BTW installation, to turn off warnings during installation of BTW. Start
©2005 All rights reserved. | 51 |
|