Marantz VP-12S1s manual Initial SET UP, To Turn OFF the Power

Page 20

ENGLISH

INITIAL SET UP

1.Connect the supplied AC power cord.

The STANDBY indicator lights up and the projector goes into the standby mode.

2.Press the POWER ON key on the remote controller or the POWER key on the projector.

The POWER indicator lights up.

3.Press the FOCUS key on the remote controller to display the FOCUS pattern and turn the Focus ring to make an adjustment. Adjust the focus for the sharpest image possible to obtain, using focus pattern.

Press the FOCUS key again to clear off the pattern.

4.Turn the Zoom ring to adjust the size of the image.

5.Switch on the equipment connected to the projector. Press the INPUT SELECT key on the projector or the COMPONENT key, S-VIDEO key, VIDEO key, or RGB key on the remote controller.

TO TURN OFF THE POWER

1.Press the STANDBY key on the remote controller or the POWER key on the projector.

2.The fan continues to run for a while to reduce internal heat. The POWER ON indicator flashes in blue and no key will be active minute. After about one minute cooling has been provided, the unit turned off and the STANDBY indicator lights up.

16

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model VP-12S1 User Guide For the customers in the USA Important Safety Instructions Table of Contents Electronics & Software FeaturesOptics Projector Layout and Functional Overview Front and TopX c bn Right Side and Rear⁄1TRIG.2TRIGGER Height Adjustment BottomRemote Controller ¡0THEATER keyPreparing the Remote Controller Installation Recommended SettingSide view Flat viewDistance between the projector and the screen throw distance Counterclockwise Down Image Position AdjustmentTurn the Lens Shift knob to clockwise The image goes up Keystone-HElectronic horizontal keystone correction Advanced SettingKeystone-VElectronic vertical keystone correction Normal mode Zoom mode Screen Images in a Wide screenScreen Images in a 43 screen Connection with a HD-Video or PC ConnectionConnections with Video equipments Connection with a DV camcoder Advanced connectionReceiver equipment with Dolby Digital decoderInitial SET UP To Turn OFF the PowerPicture Adjust SettingOperations MenuConfiguration DisplayReset Lamp Life Reset AllTrigger2 MemoryLamp Life and Replace Lamp Lamp LifeMaintenance Cleaning the lensReplacement parts Optional accessoriesTroubleshooting Error ModeOn Screen Message SpecificationsOptical characteristics System Resolution KHz Scan Timing chartDimensions TOP Front BottomIs a registered trademark
Top Page Image Contents