NETCOMM GATEWAY™ SERIES – NB304N – ADSL2+ Wireless N300 Modem Router
In the case of a PPPoE connection, the following options are available:
| PARAMETER |
| DEFINITION |
|
|
|
|
| PPP Username and Password |
| The username and password required to access the service |
|
|
|
|
| PPPoE Service Name |
| A name to identify the configured service |
|
|
|
|
| Authentication Method |
| Select the authentication method in use on the service |
|
|
|
|
| MTU |
| Set the Maximum Transmit Unit (MTU) size for the connection |
|
|
|
|
| Enable NAT |
| Select to enable or disable Network Address Translation (NAT) for this connection |
|
|
|
|
| Enable Fullcone NAT |
| Select to enable Fullcone NAT on the connection. |
|
|
|
|
| Dial on Demand |
| Select to enable dial on demand mode. Enter the idle time to wait before disconnecting the service. |
|
|
|
|
| PPP IP Extension |
| Select to enable PPP IP Extension on the connection |
|
|
|
|
| Static IPv4 Address |
| Enter a static IP Address to utilise with the connection |
|
|
|
|
| Enable IPv6 |
| Select to enable IPv6 support for the connection. This enables the NB304N to Request Prefix Delegation and |
|
| request an IPv6 Address. | |
|
|
| |
|
|
|
|
| Enable IGMP Multicast Proxy |
| Enable IGMP Proxy mode on the connection. This is commonly used for IPTV. |
|
|
|
|
| Enable MLD Multicast Proxy |
| Enable MLD Proxy mode. This is the IPv6 equivalent of IGMP proxy mode. |
|
|
|
|
Click Next once the connection configuration details have been entered.
(a)Select the Default Gateway Interface to use for the connection and click Next
(b)Select the DNS Server Interface to use for the connection and click Next
(c)Review the configured functions of the connection and click Save/Apply to save the new WAN Service connection.
YML304X | NetComm NB304N – ADSL2+ Wireless N300 Modem |
www.netcomm.com.au | 22 |