Policy Routing
Policy Routing enables you to specify specific rules under which a route will be utilised.
To delete a route policy, click the Remove checkbox next to the selected policy and click Remove.
To add a new routing policy, click Add.
Enter the following parameters:
PARAMETER | DEFINITION |
|
|
|
|
Policy Name
Physical LAN Port
Source IP
Use Interface
Default Gateway
Enter a name to identify the routing policy
Enter the physical port to apply the routing policy to
Enter the source address of traffic to apply the routing policy to
Enter the interface to apply the routing policy to
Enter the default gateway to use with the routing policy.
Click Save/Apply to save the new routing policy entry.
RIP
The Routing Information Protocol (RIP) is a distance based routing protocol and uses hop counts as a routing metric. RIP can only be used on WAN connections which do not utilise NAT.
Select the RIP version and Operation mode to use with the specified WAN service interface.
Click Apply/Save to save the new RIP configuration settings.
NetComm NB304N – ADSL2+ Wireless N300 Modem | YML304X |
35 | www.netcomm.com.au |