JVC DLA-SX21U manual Connecting to Devices,
Connecting to Video Devices

Connecting to Various Devices

Connecting to Devices

Before connection, be sure to turn off both the projector and the device.

Connecting to Video Devices

•Thoroughly read the manual that comes with each video device.

•Use the supplied AV connection cable. S-video [Y/C] cable, BNC cable and PC Audio cables are not supplied.

Right side of projector

BNC Cable (separately available)

R PR/CR	G Y	B PB/CS	H/CS	V			DVI
					PC1		PC3
		PC2
DC OUT		REMOTE	RS-232C OUT		RS-232C IN	Y/C	VIDEO
5V }1.5A	AUDIO IN			CONTROL		VIDEO IN

PC Audio cable	S-video cable	AV connection
(separately available)	(separately available)	cable (separately
		available)

Video Device 1

VCR (Video cassette recorder)

Laser videodisc player

Camcorder

Image input

• Connect a composite image signal output device or Y/C (S-video) image output de- vice.

Sound input

• Connect to AUDIO IN terminal.

Video Device 2

W-VHS or DVD player etc.

Image input

•Connect to component signal out- put device, DTV format signal out- put device, etc.

•When the PC2 input terminal is used, the “PC2(BNC)” item in

“Options” menu must be correctly set. (☞ page 39)

Sound input

• Connect to AUDIO IN terminal.

Connection

•When connecting a video device, please use a TBC along with it, or use one with a built-in TBC.

•Use of an extension cable to connect a video device and the projector could cause image deterioration or projection failure.

•When a signal with much jitter is reproduced on a VCR, or special-effect playbacks are performed, the upper part of the image or the screen may be interrupted, erased or distorted.

21